Lock the dishwasher by pressing the control button for 3 seconds.
Locked dishwasher door.
It is about 10 years old high end model with a bull nose front to cover the catch handle.
The second is to activate the safety switch.
Hold it down until the red light labeled control locked blinks on.
Holding the heated dry key would only lock or unlock the controls.
If out of alignemnt the dishwasher door latch cannot connect to it and the door will not close.
Without knowing the model of dishwasher she has my best guess would be that the door handle or latch is broken.
This is the part that the dishwasher door lock latch hooks into when the door is closed.
First check your dishwasher door and door gasket.
To unlock the dishwasher control panel press and hold the no heat dry button for 4 deliberate seconds and the lock on light should turn off.
The control panel is above or on the upper edge of the dishwasher door.
Has anyone run into this or have any thoughts on how to least destructively get this thing.
The handle to open the door has somehow broken and it does not seem possible to open the door.
Troubleshooting lock mode when you press one of the control buttons while the dishwasher is in lock mode the button should flash only four times.
Check to be sure that the strike plate is properly aligned.
The available buttons differ from model to.
Even though none of the controls works in lock mode you can still open the dishwasher door.
The first is to pull the door tight and keep it closed to prevent water leaks.
The control lock deactivates the control panel touchpad keys so the washer cannot be started but still allows the door to be opened.
The control lock function on a whirlpool dishwasher is a child safety feature.
The reason this happens is because the plastic on the latch starts to warp over time and then instead of flicking backwards when you open the door it will flip forward and over extend past the locking position since there is no latch striker to stop it.
When the dishwasher door latch does not operate as it should your machine will not run this can be a major annoyance but should also be an easy thing to repair.
Actually most dishwashers do not have the ability to lock the door.
Kitchenaid dishwasher door is locked.
Here is a link for the owner s manual on this dishwasher in case you need it.
The latch serves two purposes.
The control should then work normally.
3 dishwasher door strike plate the dishwasher strike plate is located on the dishwasher frame.
If it is a maytag jenn air brand she might be able to just pull the door open with a little force.
The latch can 39 t be reset if it went into the door lock position when the door was open.