Prime line diecast with wood handle gray patio door handle tee lock keyed 33 model c 1064 27 98.
Lock holes in door.
Usually the backset measures 2.
For the first.
Turn the door over remove the plywood disk from the hole saw and use the hole saw to drill through the other side of the door until the two holes meet.
Have a door out of alignment due to settling.
Prime line sliding patio door wood pull chrome plated brackets 49.
The centerline of the holes must be at the same height and they must be drilled at the precise 90 degree angle to the face of the material being drilled.
Find a hole saw that is just a bit bigger than the existing hole.
Clamp a piece of plywood to each side of the door lining up the center lines with the center line on the door edge.
I picked up an oak short from the local big box.
For this job the original door was made of oak.
Need to drill a new hole really close to the original one.
Cross or edge bore.
We refer to the round holes where the door lock is installed as bore holes brush up on your door hardware terminology here most doors have one two or three bore hole.
Door lock openings are located roughly 2 3 8 inch to 2 3 4 inch away from the edge of the door and aligned with the center line of the doorknob.
Plug an old lock hole step 1.
Pick your hole saw.
If the door has no bore holes you can simply install a non turning or dummy knob or lever that serves as a decorative door pull.
The small hole along the edge of the door frame usually measuring about 1 inch in diameter.
Use a hole saw to drill through the plywood and halfway through the door.
If you want your door lockset to operate smoothly and not bind up when you turn the doorknob or try to lock it it s imperative the two holes you drill align perfectly in both directions.
The stripped hole repair kit from king s original ha.