Kenmore Ice Auger Not Working

From an ejector arm that refuses to budge to a kink in the water lines that run behind the fridge there are a few reasons that can prevent ice from dropping out of the kenmore elite s dispenser.

Kenmore ice auger not working.

If the refrigerator ice maker is not working the door switch might be defective. If the auger motor is burned out or defective the ice won t move forward and fall through the chute. If the auger is not turning you should first verify the motor is operating. The auger is driven by a motor mounted behind the bin with a set of drive forks on the gear box shaft.

When you push on the ice dispenser lever in the door of your freezer the ice drops from the dispenser and into your glass. The water inlet valve which supplies water to the ice maker is designed to work with a minimum of 20 psi of water pressure. Ice maker is making ice auger seems to work but ice bunches at funnel and plugging up dispenser. I cleaned it out several times and turn off ice maker to see if something was not frozen.

If the ice maker is not working the water pressure in the house might be too low. If the auger motor does not have continuity or if. Ice maker stopped working control arm out of position. If the auger motor is defective pull out the ice bucket and turn the bucket auger by hand.

Check the owner s manual for information about the pause feature and make sure it. The control arm may have inadvertently been moved or possibly fallen off which can pause ice maker functionality. The motor gear box normally makes enough noise that you can hear it with the freezer door closed. Many ice makers have a control arm that activates a pause feature when the ice bin is full.

The gear box turns very slowly but has lots of power to push the ice. If the auger turns freely use a multimeter to test the auger motor for continuity. If the kenmore ice maker is not working then a little investigating and troubleshooting may be able to alleviate the issue.